Mutec MC-6 Manual de servicio

Busca en linea o descarga Manual de servicio para Equipo musical Mutec MC-6. Mutec MC-6 Technical data Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 22
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
Operating Manual
MUTEC GmbH · Fon 0049-(0)30-74 68 80-0 · [email protected] · www.mutec-net.com
Vista de pagina 0
1 2 3 4 5 6 ... 21 22

Indice de contenidos

Pagina 1 - Operating Manual

Operating ManualMUTEC GmbH · Fon 0049-(0)30-74 68 80-0 · [email protected] · www.mutec-net.com

Pagina 2

10Control Elements and TerminalsMC-3+ Front Panel432 51 6 71 »POWER« This red LED lights up when the unit is switched on with the rear panel power swi

Pagina 3

11Control Elements and Terminals432 51 6 71 »WCLK OUT 1– 3« These 3 pairs of Word Clock outputs transfer all standard Word Clock rates and Word Clock

Pagina 4 - Safety Instructions

12OperationGeneral System OperationOperating the MC-3+ is very easy! The device is fully operated using the two keys on the front panel.»MENU« Key Pre

Pagina 5 - Warranty Regulations

13Operation1) Which operation mode is basically needed? → »MODE«Should my MC-3+ work as clock generator (»INTERNAL«), as clock distributor (»EXTERNAL«

Pagina 6 - Introduction

14OperationThere are three basic operation modes of your MC-3+ Smart Clock:»INTERNAL« The MC-3+ runs as a clock generator and is locked to its interna

Pagina 7

15OperationSelecting References Selection of references is mainly used when the MC-3+ is set under »MODE« to »EXTERNAL« or »RE-CLOCK«.The above settin

Pagina 8 - Installation

16OperationAn optical S/P-DIF digital audio signal is re-clocked. All outputs provide their signals on the same clock rate like this one of the incomi

Pagina 9

17Operation»HOLD« This red LED lights when the external reference clock signal is interrupted or lost. The frequency synthesizer of the MC-3+ kee-ps g

Pagina 10 - MC-3+ Front Panel

18AppendixPin Assignment of the ConnectorsMains 11 Live, phase (brown; USA: black) 2 Protective earth (green/yellow; USA: green) 3 Neutral (blu

Pagina 11 - MC-3+ Rear Panel

19AppendixFor additional information, please refer to page 11 under »Wiring the Interfaces – Word Clock«.Inside View – Word Clock TerminationWhen the

Pagina 13

XX XX20Word Clock & 10.0 MHz Input (WCLK + 10.0M)Interface 1 x BNC, 200 mV-7 V, unbalanced, input impedance 75 Ω (can be switched off, see Page 18

Pagina 14

XX XX21AppendixPower SupplyType Internal, switching power supplyInput Voltage 85 V – 264 V (automatic adjustment), 47 Hz – 440 HzPower Consumption max

Pagina 15

MUTEC GmbH · Fon 0049-(0)30-74 68 80-0 · [email protected] · www.mutec-net.com

Pagina 16

3ContentSafety Instructions ...

Pagina 17

4Safety InstructionsGeneral Instructions To reduce the risk of fire or electrical shock, do not expose this appliance to rain or moisture, direct sunli

Pagina 18 - Appendix

5Warranty Regulations§1 WarrantyMUTEC GmbH warrants the flawless performance of this product to the original buyer for a period of two (2) years from t

Pagina 19

6IntroductionThank you very much for buying the MC-3+ Smart Clock, a Synchronizable Digital Audio Master Clock Generator, from MUTEC!General Descripti

Pagina 20

7IntroductionIncrease of clock signal reliability during live eventsMultiple clock rate synchronizationPeripheral MUTEC ProductsUSB InterfacesMC-1.2 T

Pagina 21

8InstallationContent of the BoxYour MC-3+ was packed carefully. Nevertheless we recommend to check the content directly after opening the package:1 x

Pagina 22

9InstallationFor devices which have no termination of the Word Clock input, e.g. RME Hammerfall with Word Clock i/o, Alesis BRC or M-Audio ProFire Lig

Comentarios a estos manuales

Sin comentarios